Step by Step DIY Guide to Fit a Bathroom Sink

Step by Step DIY Guide to Fit a Bathroom Sink

The simplest way to change the look of a bathroom can be achieved by just fitting a bathroom sink. Whether you go for a wall mounted minimalist basin or a traditional style pedestal, it would still make a statement. You can remove your old sink and replace it with a new designer one from http://www.jtspas.co.uk. You can always use the services of a profession fitter or plumber if you do not feel confident to do the job yourself. However, the steps are quite simple and they are as follows ?

? Things Required ?

  • Spanners (adjustable);
  • Stud detector;
  • Drill;
  • Tape measure;
  • Spirit level;
  • Tube cutter or Hacksaw;
  • PFTE tape;
  • Wrench (adjustable);
  • Pencil; and
  • Screwdriver.

? Step 1: Remove the Old Sink ?

Before you start the work, make sure that the main water supply is turned off. Then, remove the old basin?s taps and reach out to the underside of your sink to remove it. You can do this by unscrewing the bottle trap or waste. Make sure all screws and wall fixings are also removed.

? Step 2: Align the Sink With the Wall ?

Use the spirit level for proper and straight alignment of the sink against the wall. After this, mark the spots for the placement of the wall fixings (under the basin) and the point where the sink will sit with the help of a pencil. This is a rough mark for ensuring accuracy.

? Step 3: Check the Water Connections ?

Usually, this step is simple as you just need to connect your main water supply waste and feeds to the taps. However, for newly installed taps, you will have to make the connections by using waste pipe parts and connector pipes. The new taps must be sealed water tight with the help of screws and washers. Before you start with the fitting of the worktop, all the sundry parts like wastes and taps must be fixed. This would make the final connections a breeze to install.

? Step 4: Connect the Pipework ?

If it is a wall mounted sink, you need to use screws to fit it tightly in place. When you buy your basin, you will get Fischer fixings or special fixings for this purpose. After this step, use all the supplied parts for connecting the waste pipes and overflow, and any other pipes that may be required.

? Step 5: Seal the Sink ?

Use silicone'sealant (waterproof) for sealing around the basin and getting a perfectly seamless finish. After that, make sure that before the water gets turned on, every bend and kink in the pipework is checked and sorted out.

As a tip, wrap masking tape around the pipe you are going to cut so that the result is smooth and straight, and any accidents can be avoided. This guide is a rough one for normal basins but the requirements of special basins may be different. Study the structure of the basin properly and always consult a professional fitter if you are in doubt.