Choosing and Installing Easy Access Shower Enclosures
Easy Access Shower Enclosures are designed to prevent water pouring from the shower to be kept off the bathroom floor. It can be rather messy when water gets to drip on the floor of the bathroom. Some homes still use shower curtains for this purpose but enclosures are more efficient and more durable. When choosing enclosures for the shower area of the bath, it is suggested that prior to buying anything, take a glimpse inside bathroom fixture outlets to tangibly have a look at units that have already been assembled.
This is an opportunity to check out the product’s quality as well as rigidity. You have to make sure that the enclosure door opens or moves easily without vibration. If the door is a swing type, have a look at the hinges for you to know the way they are reinforced. The door should have excellent magnetic shutter. You also have to inquire if the product is to be delivered assembled already or not. Actually, people would prefer fully assembled items. Before deciding on paying for shower enclosures, check out first the finish. Be certain that the screw heads are concealed and the cut outlines over the door and panel have been covered to keep the water from getting inside.
In the installation process of your bath’s enclosure, it is recommended to have with you the instruction manual that came with the item. For the reason that no shower enclosures are absolutely similar, the process of installation may differ. Even if the units had come from one company or manufacturer processes remain distinct. The shower tray serves as the base of the enclosure and it may be important that it is assembled and affixed accurately. With the use of spirit level, make certain that the shower tray is levelled. Place a marking on the wall about a fourth of an inch from the end of the shower tray and take out the wall outlet form the panel at the side. It is necessitated to take out the post on the bend as well as the vinyl covering from the panel. Keep the wall outlet in vertical position aligned with the marking, then make marks through the holes on the wall. Drill and plug these holes and screw on the outlet to the wall. With the use of a sealant prior to the final tightening of the screws, seal in the gap between the outlet and the wall and then slide in the enclosure side panel. Make sure everything is aligned then put sealant amidst the sections.
Be sure that the post at the corner is in vertical position prior to drilling in holes and placing the screws. Affix the caps to the corner and wall channels. Turn the door around and screw in the wall channel towards the wall. Glide in the hinge side into the wall channel that is already in position. Adjust the door so it comes out at the centre inside the channels. Screw in the frame of the door to the channels and change the cover vinyl.
Showing products 1 to 7 of 7