Insignia GT9012 Quadrant Steam Shower Cabin 800mm x 800mm Unit Enclosure
Check out this his unique 800mm x 800mm steam shower cabin is ideal for the smaller bathroom or en-suite.
100mm clearance should be allowed for between the cabin roof and ceiling to allow adequate venting. It is essential that a fully qualified electrician and fully qualified plumber install the unit in accordance with current regulations. The product requires hard wiring into the mains.
Backed Up With a Comprehensive 1 Year Parts RTB Warranty
*Radio reception is dependant on area and availability. Please be aware before purchasing, We offer no guarantees regarding the radio reception in their range of steam showers. Above Steam Shower Features Guides shows a combined list of all features from across entire range of shower cabins, steam showers and steam shower whirlpool baths, not all features are available on each product.
Additional Installation Notes:
Electrical: This steam shower cabin requires 1 x 13amp electrical supply. It comes with a plug and RCD fitted, however we recommend you remove the plug and have the cabin installed to a fused spur. If you have an RCD fitted within your mains board you may also remove the RCD fitted to the shower flex.
Water: The cabin requires 1 x hot and 1 x cold water supply. The household water pipes should be fed to a point approximately 1 metre off the floor in the corner where the cabin is to be fitted. Balanced water pressure is required, between 1.5-3 bar. If using a gravity fed system we recommend you use a shower pump, to provide the required water pressures. We do not supply pumps. The shower cabin is a freestanding product and as such we would recommend your fitter does not fit the shower into locations that mean the cabin cannot be moved away from the wall if needed. The couplings on the cabin to connect to your water supply are standard 15mm compression fittings.
Some of our products arrive in large boxes, please ensure that you have enough room to manoeuvre the boxes and their contents to the installation location.
* All Insignia Products come with a minimum 12 months parts warranty as standard. No assembly / labour costs / repair costs are covered as all Insignia Products are self assembly. This is easily extended to 60 months (Five Years) by registering your warranty details here: http://www.insigniarange.co.uk/warrantyreg.aspx . NOTE! No registration means your warranty will expire in 12 months from your date of purchase. You have 60 days from the date of delivery to register.