Water supply requirement: separate hot and cold inputs are required, each at a pressure of 2 - 3 Bar. NB: if the water pressure is below this range a twin negative head pump must be used to boost the hot and cold supply.
Please note you must register your purchase on Insignia's Website this will ensure you receive your warranty and a speedy resolution should any problems ever arise. Please Visit http://www.insigniarange.com/warrantyreg.asp
Additional Installation Notes:
Electrical: This steam shower cabin requires 1 x 13amp electrical supply. It comes with a plug and RCD fitted, however we recommend you remove the plug and have the cabin installed to a fused spur. If you have an RCD fitted within your mains board you may also remove the RCD fitted to the shower flex.
Water: The cabin requires 1 x hot and 1 x cold water supply. The household water pipes should be fed to a point approximately 1 metre off the floor in the corner where the cabin is to be fitted. Balanced water pressure is required, between 1.5-3 bar. If using a gravity fed system we recommend you use a shower pump, to provide the required water pressures. We do not supply pumps. The shower cabin is a freestanding product and as such we would recommend your fitter does not fit the shower into locations that mean the cabin cannot be moved away from the wall if needed. The couplings on the cabin to connect to your water supply are standard 15mm compression fittings.
Some of our products arrive in large boxes, please ensure that you have enough room to manoeuvre the boxes and their contents to the installation location.
Click Here For The Steam Shower Warranty & Install FAQ