Special Offer Price
Aqualux Florenta Quadrant Steam Shower Enclosure Cabin 900mm x 900mm
The Aqualux Florenta Quadrant Steam Shower Cabin Includes 4 body massage jets to refresh and relax you, whilst the steam will nourish and detoxify your skin to leave you with a healthy glow and feeling of wellbeing.
Includes roof, walls, shower tray and drainage kit
Backed Up With a Comprehensive 2 Year Warranty
Fully European CE Approved
Dimensions: 900mm * 900mm * 2200MM
Operates at Pressures of 2 - 3 Bar we recommend 2.5bar for the best performance, we recommend these 2 pumps, Salamander ESP75 or ESP100 shower pump which we can supply.
Installation guidelines for
Water supply requirement: separate hot and cold inputs are required, each at a pressure of 2 - 3 Bar. NB: if the water pressure is below this range a twin negative head pump must be used to boost the hot and cold supply.
A pump must not be used on the output of a combi boiler.
100mm clearance should be allowed for between the cabin roof and ceiling to allow adequate venting. It is essential that a fully qualified electrician and fully qualified plumber install the unit in accordance with current regulations. The product requires hard wiring into the mains.
Additional Installation Notes:
Electrical: This steam shower cabin requires 1 x 13amp electrical supply. It comes with a plug and RCD fitted, however we recommend you remove the plug and have the cabin installed to a fused spur. If you have an RCD fitted within your mains board you may also remove the RCD fitted to the shower flex.
Water: The cabin requires 1 x hot and 1 x cold water supply. The household water pipes should be fed to a point approximately 1 metre off the floor in the corner where the cabin is to be fitted. Balanced water pressure is required, between 2-3 bar. If using a gravity fed system we recommend you use a shower pump, to provide the required water pressures. We do not supply pumps. The shower cabin is a freestanding product and as such we would recommend your fitter does not fit the shower into locations that mean the cabin cannot be moved away from the wall if needed. The couplings on the cabin to connect to your water supply are standard 15mm compression fittings.
Some of our products arrive in large boxes, please ensure that you have enough room to manoeuvre the boxes and their contents to the installation location.
This product is eligible for our low cost finance option.
Add your item
to the basket
Select V12 Finance