Aqualux Crysta Round Steam Shower Cabin 930mm x 1100mm D Shaped Shower Enclosure Unit
For those who demand excellent functionality with high-impact design, the Crysta Round Steam Cabin has it all. Frameless styling is complemented with polished chrome effect fittings and an aesthetic opaque glass back panel.
There’s a stone effect single seat and a 3KWsteam generator, as well as a hand shower and 6 body jets, radio and speaker with USB connector for an MP3 player, a 8 inch diameter shower head with chrome finish. LCD touch screen control panel and cleaning is easy with a built-in self-cleaning function. Crysta cabins are 2150mm high and come with a 2 year guarantee.
Working Voltage: 220 – 240 Volt
Power consumption: 2500 ~ 3800 watts
Maximum current draw: 15.8 ~ 17.8 Amps
Water consumption: 900 ~ 1200 Ltrs per hour (12~ 14ltr min)
Minimum cold water supply: 1.5 ~ 3Bar
Minimum working water pressure of steam generator: 0.75Bar
150mm clearance required from ceiling to cabin to allow adequate venting.
100mm clearance must be allowed for between the cabin roof and ceiling to allow adequate venting. It is essential that a fully qualified electrician and fully qualified plumber install the unit in accordance with current regulations. The product requires hard wiring into the mains
Operates at Pressures of 1.5 - 4 Bar and flow rates from 10/12 litres per minute
Please note these units must be installed by qualified plumbers and electricians for legal and warranty reasons.
Additional Installation Notes:
Electrical: This steam shower cabin requires 1 x 13amp electrical supply. It comes with a plug and RCD fitted, however we recommend you remove the plug and have the cabin installed to a fused spur. If you have an RCD fitted within your mains board you may also remove the RCD fitted to the shower flex.
Water: The cabin requires 1 x hot and 1 x cold water supply. The household water pipes should be fed to a point approximately 1 metre off the floor in the corner where the cabin is to be fitted. Balanced water pressure is required, between 1.5-3 bar. If using a gravity fed system we recommend you use a shower pump, to provide the required water pressures. We do not supply pumps. The shower cabin is a freestanding product and as such we would recommend your fitter does not fit the shower into locations that mean the cabin cannot be moved away from the wall if needed. The couplings on the cabin to connect to your water supply are standard 15mm compression fittings.
Some of our products arrive in large boxes, please ensure that you have enough room to manoeuvre the boxes and their contents to the installation location.
This product is eligible for our low cost finance option.
Add your item
to the basket
Select V12 Finance